Find the center of your license plate and bend it to a 45 degree angle.
Diy birdhouse with license plate roof.
Using a pencil mark where the holes of the license plate will be on the edge of the birdhouse.
Diy nail less screw.
Build a bird house.
First mark the center of the license plate as shown below.
See more ideas about bird houses license plate bird house.
May 18 2020 explore bill bramblett s board license plate birdhouses on pinterest.
Cut two pieces of 3 4 inch wood measuring 4 1 2 inches square with a power saw.
Lay the front piece of wood on a flat surface in a diagonal position.
Drill holes for the pan head screws or roofing nails.
If you don t have an old license plate you can substitute the license plate roof with a piece of 12 x 6 galvanized metal.
This will prevent the wood from splitting when you put in the hardware.
Simple bird house plan.
Attach the license plate to the birdhouse using only screws.
The birdhouse will hang in a diamond position with a point at the bottom and the point of the bent license plate roof at the top.
The depth in 5.
Use a pop rivet gun to connect plate 1 to plate 2 checkout the video below minute 14 to see us use the pop riveter drill holes through the roof into the tabs use a pop rivet gun to fasten the roof to the tabs one rivet on each side of the roof is all that is needed cut a piece of scrap wood to fit the bottom of the house.
This plan will get you a very simple and straightforward birdhouse that can be nailed to a tree or post.
34 diy bird houses 1.
Diy birdhouse with a pretty penny roof.
For the roof we recycled some old license plates and painted them the kids favorite colors yes even the camo wood.
Center it over the roof support on the house.
This cute little birdhouse is made from just four small scraps of wood and uses a folded license plate as the roof.
Most of this birdhouse is built with wood but a metal license plate makes up the roof.
Just like the other nest boxes one side opens by pivoting on two screws for access to the interior.
Building a rustic style birdhouse from cedar pickets diy.
These are the front and back of the birdhouse.
Keep bending until the angle on the license plate matches the roof angle on the birdhouse.
It hangs from a piece of wire that is threaded through holes drilled in the front and back sections.